1. N5CR Timer with Selected Control Voltage
2. DIN / Panel Mounting Socket
32-N5CR***
32-P2CF8
For Flush Mounting (IP50)
1. N5CR Timer with Selected Control Voltage
2. Flush Mounting Clip
3. Back Connection Socket
32-N5CR***
32-LS5Y
32-P3G08
For Flush Mounting (IP65)
1. N5CR Timer with Selected Control Voltage
2. Timer IP65 Seal Kit
3. Flush Mounting Clip
4. Back Connection Socket
32-N5CR***
32-N5IPK
32-LS5Y
32-P3G08
Technical Data
Dimensions (H x W x D)
Panel Cutout
Control Voltages
Contact Rating
Operating Temperature Range
Battery Reserve
Display
Minimum Switching Time
= Thermal (Ith)
= Resistive Load
= Lighting Load
= Direct Current
= 50 x 50 x 78mm
= 45 x 45 mm
= 24V, 110V, 240V & 415V A/C
= 12V & 24V D/C
= 16A / 250V A/C
= 16A / 250V A/C
= 8A / 250V A/C
= 1A / 24V D/C
= -10 ° C to + 50 ° C
= 3,000 Hours (Approx)
= 6mm Liquid-Crystal Display (LCD)
= 1 Minute
Programming Instructions
Setting Actual Time
1. SET DAY:
Hold down the
button and press the
button until the correct day appears at the top
of the display.
2. SET TIME:
Hold down the
button and press the
and
button and set the correct time.
NOTE: You may have to cycle through the hours twice to
set AM or PM. (on the left side of the display).
Setting the Switching On/Off Times
1.
Push the
button once. 1on will appear in the bottom
left of the display.
2.
Push the
button and select the day or days required to operate.
An individual day: Mo or Tu or We or Th or Fr or Sa or Su.
Or a group: Mo, Tu, We, Th, Fr or Mo,
Tu, We, Th, Fr, Sa, Su or Sa, Su can be programmed.
3.
Select
the hour and minute required for the first "on"
time.
4.
Now
the time and day for the first "on" time has
been selected the first "off" time is selected.
5.
Push the
button once. 1off will appear in the bottom
left of the display.
6.
Push the
button and repeat the steps in 2, then the
and
.
7.
Push the
button again and 2on will appear to indicate
that a second "on" is ready to be set
and then repeat the steps used to programme 1on/off to set up to 6on/off times.
8.
Press the
button to run through the times set to ensure they
are correct.
9.
Press the
button to return the real time clock display.
10.
The
button can be used to "reset" or change
a particular power on/off entry, four dashes will
appear and the setting can be changed. When you
"recall" an entry it will return to the
values that were set before you performed a reset.
11.
To set the unit to Automatic
Control. Press the
button until the Bar at the bottom of the display
appears above "Auto".
12.
To Manually operate the unit.
Press the
button until the Bar appears above "Off"
or "On".
13.
When
the unit is "ON" the red LED (out) will glow.
